Electronics Box

thingiverse

The Sanguinololu board's electronics box is replicated from a perfect box used for Huxley. The box only utilizes the lid after deciding that 10mm holes are sufficient for ventilation, while the original lid had a fan mounted. To accommodate a 130x130mm printing area of Huxley, the box was split in half. Measuring 144x82mm and 29mm deep outside, with walls about 2mm thick, the box also features an extra slit on the lid for an SD-Card reader. To assemble, print two of each part (lid and bottom), join them using the 10mm holes, then fasten with four M3x40 screws and M3 nuts per lid and bottom piece.