Electronic Component Stackable Drawers

This remix offers a set of drawers with a height of 20mm and 40mm and both a width of ~19 cm. You can choose between thin walls (0.8mm) that are easy to print but a little wobbly and sturdier walls that are 1mm wide but require some special slicer settings. Additionally a version with a height of 20mm but only with a width of 16cm.

The shelves for the drawers are identical for the 0.8mm and 1mm variants.

The abbreviations for the file names are *FB* = FrontToBack divider, *LR* = LeftToRight divider. The narrow ones are named with *20s*.

---

# Settings

I print the **1mm** variant with PLA with following Cura-Slicer-settings:

Layer height: 0.3
Init. Layer height: 0.2
Line Width: 0.53
Initial Layer Line Width: 60%

Wall thickness: 1.06mm
Wall Line count: 2
Optimize Wall Print order: Off
Compensate Wall overlaps:Off
Fill gaps between walls: Everywhere
Filter Out tiny gaps:ON

Infill: 10% (Gyroid)

Nozzle-Temp:215C
Bed Temp:40C
Flow:90%

Infill speed: 60mm/s
Wall speed: 50mm/s
Top/Btm Speed:60mm/s
Init. layer speed: 50mm/s

Retraction distance:6mm
Retraction Speed:40mm/s
Retraction extra prime amount: 1mm³ (Without I got under extrusion after a retraction and a long travel)

(Experimental-Settings)
Small Hole Size: 7.0mm
Small Feature Speed: 40%