Electronic Box Caja Electrónica

thingiverse

I'm building my first enclosure since I couldn't find any that met my requirements. The case comes with two 80x80, 12v fans that can be connected to molex from the power supply without cutting any cables. This is version 1.0 and hasn't been tested yet, so it should probably be a 0.x instead xD. I added two bases that are trimmed to prevent warping. Once printed, hinges for chain carrying will be designed along with cable clips. The case has an isolated base of 6mm so the screws holding the electronics don't touch the floor (to prevent shorts when put on metal) and it doesn't have holes to assemble with the frame but they'll be added when I decide where the electronics will go. It's also desired to extend the ramps' LEDs outwards since they're comfortable for viewing connections and power, along with possibly adding an amperemeter to view machine consumption. As you can see, the rear fan mounts are above the floor; that was intentional. The top case covering the two coolers still needs design before printing but it won't be done until their dimensions are confirmed. I hope this helps, don't hesitate to suggest anything. Thank you and best regards