Electrolux fridge bottle shelf guides replacement

thingiverse

This is a substitute for the Electrolux fridge bottle shelf replacement parts manual\n\n\nInstructions\nRequirements:\nAdjustable wrenches (or any tool that enables you to place the nuts through the small space) \nPlywood screws (4x, 3mm in diameter, 10mm long) \MMC-6 screws (4x, with corresponding locknuts and flat washers for 8-10mm spacing)\n MMC nuts (4x)\n MMC locknuts (4x, with pre-installed retaining rings or self-threading fasteners) (optional) InstaMorph adhesive tape (for bonding reinforcement) (optional)\nInstallation Guide:\nAs you proceed through this project, repeatedly fit the component into position to ensure correct measurements and alignment of the screw holes\n Utilize a high-torque cutting tool such as a drill or reciprocating saw to remove part of the original shelf (followed by hand polishing for even edges) \nDrill four precise pilot holes on one side of the removed section using your Dremel with suitable metal cutting and/or carbide-coated drilling accessories, depending on the nature of the work piece. Drill through at low speed while feeding in gently. Maintain even depth for symmetrical results.\n Install component to corresponding position. Introduce provided screws.\n Place MMC washers if specified as necessary\n Add nuts lastly \n Secure fasteners by hand before final tightening\n Reinforce part using InstaMorph (optional)