ElectroCooler footwell vent / blend valve cover

thingiverse

This is my take on a refined version of the factory deflector plate for the foot well vent / blend valve and the 'snorkel' modification shown at the ElectroCooler install manual. It contains three files: cover, vent, and dividing wall (tw). The new cover is installed instead of the original cover with the original screws. The dividing wall fits into the cut-out on the inside of the cover and is secured with a drop of super glue. Make sure the direction of the triangle shape of the dividing wall does fit the shape of the blend valve (left and right side of the car is different!). I used a small piece of pre-compressed tape to close the gap (the factory blend valve does tend to wrap a bit). Use half of the length of the 50mm pipe provided with the ElectroCooler. The pipe is secured to the cover with a cable tie (250mm long). The vent is secured to the other end of the pipe with a cable tie and positioned in the car with a self-adhesive mounting base. I did use PETG in black as printing material with the standard setting: heat bed temp 70°, nozzle temp 230°.