Electra RC Model - Port Flaps - Section 9.
thingiverse
This is the final section of the Port Wing. The flaps are similar to Fowler Flaps. They are controlled by an Arduino. When the Arduino gets a Flaps position signal from the RC receiver channel, the servo drives a screw thread that drives the flaps out. The servo has been modified to be continuous 360 degree drive in both directions. As the the flap is extended, the "turnbuckles" adjust the angle of the flap from horizontal to drooping at about 45 degrees when fully extended. There is feedback to the controller of flap position via a linear pot. Details of this system will be covered in a video on Youtube Bathog Technologies.
With this file you will be able to print Electra RC Model - Port Flaps - Section 9. with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Electra RC Model - Port Flaps - Section 9..