Elder Wand (Dumbledore Wand) from two parts with possibility printing horizontally and vertically

prusaprinters

<p>Because my girlfriend sat on my wand from first attempt (<a href="https://www.thingiverse.com/thing:2508722">https://www.thingiverse.com/thing:2508722</a>) and broke it, I searched another, because model from TonePLA was too much symmetrical and didn't look like from movie.</p> <p>I decided to make my own model by combining different two models.</p> <p>I took whole wand from gpass model (<a href="https://www.thingiverse.com/thing:3467035">https://www.thingiverse.com/thing:3467035</a>). On this wand I didn't like part with runes. Runes weren't correct and whole part was too big.</p> <p>So i took another model from captfoss (<a href="https://www.thingiverse.com/thing:3265566">https://www.thingiverse.com/thing:3265566</a>). This model has perferct part with runes, but another part of wand(dotted part) is too symmetrical(It is wand made by death so I imagine it more historical and not uniform :-D) and i didn't like curved parts.</p> <p>Whole model was resized to 15 inch (38,1 mm) from gpass 35,5 mm.</p> <p>After combining these two models, wand is almost perfect for me.</p> <p>Model has two parts and it is possible printing it horizontally and vertically. There is different printing and information is on another part.</p> <p>HORIZONTALLY PRINTING - right side of every photo<br/> Pros: model is stronger because line is longer, model has better detail of top of wand, better handle from lower side, printing whole print in full speed.<br/> Cons: worse lower and upper part (print side), runes on lower and upper part is very bad, more support parts, taking out supports little bit destroy details.</p> <p>VERTICALLY PRINTING - left side of every photo<br/> Pros: better detail of every parts, runes on wand are amazing, almost no supports,<br/> Cons: top of second part of wand must be printed on 15 % of speed, because vibration is very bad for top and result is not nice, wand is more fragile</p> <p>Difference between printing is on detail of photos - top side and bottom side.</p> <p>Elder wand stand you can find here: <a href="https://www.thingiverse.com/thing:4112753">https://www.thingiverse.com/thing:4112753</a></p> <h3>Print instructions</h3><h3>Category: Props Print Settings</h3> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> I3 MK3S</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0,1</p> <p><strong>Infill:</strong> 20 %</p> <p><strong>Filament:</strong> Prusament PLA Silver</p>