Ekobots - Table Fix and Join for Mendel Prusa.

thingiverse

Table Fix and Table Join for Mendel Prusa. For use with PCB 214mm x 214mm x ~2mm and glass 214mm x 200mm x 2mm. I created and added a join for 2 tables. You do not need it for a single table, files: table_fix_TJ.stl and table_fix_BJ.stl. You can help me to do more things like this. Buy my designs at pinshape:http://pinshape.com/users/27920-jsirgado. The OpenSCAD file is there; you can change all. Instructions: Use 3mm screws, nuts, and washers. In the center hole, use a minimum of 40mm height screw + coil. In other holes use a 20mm screw. If you use the table_screw_fix, use glue to fix the nut in it. I created and added a join for 2 tables, but just for configurable printers with correct electronics. For it, you can use 2x glass 214mm x 200mm x 2mm or 1x glass 428mm x 200mm x 2mm. If you know an electronic solution for 2 or more PCB beds for a standard board please tell us. For all configurations I recommend using "Kapton Tape" on the glass in the PCB side and a "Glass Wool" under the PCB. You do not need kapton tape over the glass in the print area. With a brush, use a magic portion (50% water and 50% white glue). No toxic, easy to use and clean; but please... DO IT BEFORE HEAT THE BED. 1 - The tape will protect you from glass shard and the PCB from the glass. And the surface of the table will have more homogeneous temperature. 2 - The glass wool will save printer electronics, money, electricity, and the planet.