EIBOS Cyclopes Bearing Riser

prusaprinters

For the sides element, just lower model 7mm in the Z-axis 3 parts riser that allows to avoid overhearing especially PLA filament when they are dried. There are 2 types of riser.original with a straight part in the middlefixed with a little bend in the middle to allow drying full spoolsI tried all of my filaments and everyone fits in but there is a small amount of space between the top and spool, so if you have a problem, let me know, and I will make it a little bit smaller.Print SettingsI used PETG and it's holding up fine.  You could use ABS or ASA if you are concerned about heat warping.I printed it in standard settings, 15% infill, with support, on the side, and it comes out nice, but you will maybe need to make a thinner layer height.Even after using the riser, I don't raise the temperature sensor, based on measurements from the bottom of the dryer, it is a good placement for this built-in sensor.