Ego 21" Snowblower Skids SNT2110/SNT2112/SNT2114

thingiverse

OverviewThese skids allow an Ego 21" snowblower to work on gravel & other non-cement surfaces. They lift the scraper bar about an inch off the surface. The wide skids work better when the ground is not frozen and/or the snow is light & fluffy. They use the same bolts & bolt pattern, so they can easily be swapped out.Supports are not necessary. The wide skids have an integrated support. Both sets need to be reamed out with a 5mm drill bit prior to installation.InstructionsClamp the skid to the side of the snowblower, lining the ledge on the skid up with the bottom of the snowblower sideUsing the skid as a drill guide, drill a 5mm hole through the snowblower side housingInsert M5 bolt from inside of the snowblower housing and screw on nutAdjust clamp and repeat process for the second boltTools RequiredDrill5mm drill bitClamp (optional)Deep 8mm socket (for wide skids only)Parts Needed4 - M5 x 25mm4 - M5 lock nuts or8 - M5 nuts (using four as jam nuts)