Eggfinder LCD Receiver Round Case

thingiverse

Most Eggfinder cases are a bit boxy; this is an attempt to make something a bit more rounded. The case has mounts for both optional GPS module and optional Bluetooth module. Because of the supports that will be required during printing, this is not not a beginner printing project. A cleanup of supports will be needed. The case should look OK after some basic removal of supports using exacto knife. However, if going for the good finished look, a better final result will be obtained after sanding, filling, and painting the case. Don't print in PETG if planning to paint the case later. The case will fit battery no larger than 71x25x14mm (i.e. approximate dimensions of Turnigy Nano-tech 950mah 2S 25~50C battery). Use padding (e.g. folded piece of paper towel or foam) as needed to get snug fit for the battery. Notes section has additional information.