Egg holder (extensible and customizable)

thingiverse

I have been searching for an egg holder that meets all the following specifications: - can hold at least 10 eggs, - fits into a refrigerator door compartment (not deeper than 100mm), - keeps the eggs stable and secure when removing the entire holder from the refrigerator, - and can be produced with a standard heatbed (200x200mm). Because I couldn't find such a model, I designed it myself. A single holder measures 50x100mm and holds two eggs. Multiple holders can be connected together in a very stable way. The printing time for a single holder (two eggs) is almost exactly one hour; 16g of filament are needed (@my printer/configuration). Up to four holders can be easily positioned on a 200x200mm heatbed and thus printed in a single job. The eggs must have a maximum diameter of at least 35mm in order not to slip through the holder. If necessary, the parameters can be adjusted in the Customizer. To remove a single egg, lift it from the bottom with a finger. BTW: For a secure stand, at least two holders should be connected to each other.