Egg Cup project by Mayku

cults3d

Fetch the egg cup template from your FormBox starter kit and remove any plug in it, which blocks air from being sucked out of the center. Add air holes to allow air to flow freely through your design to the vacuum plate. You are now ready to use this template to create a whole set of egg cups by taking a Mayku Cast Sheet from the starter kit, peeling the protective film from the top of the sheet, and placing it in the FormBox. Start to heat the plastic until you see ripples at the edges of the sheet and a droop in the middle. Place the egg cup template in the center of the vacuum plate and form the template with the Mayku Cast Sheet. Allow the plastic to cool and gently pop the template out. Prepare some Mayku Pour Plaster by mixing the powder with water, using the measuring scoops provided. Pour the plaster into the mold to just below the rim and shake the mold to remove any air bubbles that will rise to the surface. Leave the mixture to set for 30 minutes before popping the egg cup out of the mold by applying firm pressure to the top of the mold. Sand the edges with fine sandpaper for a professional finish, and you're done!