EEW 6.0 Parts

thingiverse

For more information about the Electric Eel Wheel visit: www.dreamingrobots.com There are numerous parts you can 3D print for your Electric Eel Wheel 6.0 e-spinner. You might decide to print these as replacement parts, increase bobbin storage, or replace some parts with new colors. ### Bobbins For each bobbin, you will need to print the bobbin_disk1.stl, bobbin_disk2.stl and bobbin_tube.stl. Additionally, you need two R6-2RS bearings: https://www.mcmaster.com/60355K703 After printing the parts, put the bearings into the disks and then screw the disks onto the tubes. The disk1 part requires supports. ### Bobbin Release Dial This part requires an M6x1 machine screw. One that would work is available at: https://www.mcmaster.com/92005A422 ### Bottom This part covers the bottom and can hold a TalentCell 12V/6000mAh battery pack. You can reuse the screws and rubber feet from the bottom that came with the EEW 6.0. ### Flyer Arm Caps This part clicks onto the end of the flyer arms. ### Reducer This part fits into the orifice hole on the front of your EEW 6.0. It helps reduce yarn wobble when spinning thin yarn. After printing, you may need to sand its diameter slightly to make it fit better, or if the fit is too loose put a piece of tape around it to make the fit more snug. ### Quill This allows an alternative method of spinning on the EEW 6.0. This connects in the same way as the Reducer. Explaining how you actually spin using this is beyond the scope of this document. Modified it to be a better design based on feedback. ### Tension Dial You can reuse the screw and spring that came with your original tension dial.