EEEkit Hygrometer (Humidity Sensor) Through Screw Mount for Dry Box

youmagine

This is a through-hole screw mount for an EEEkit Hygrometer (Amazon link, non-affiliate). You can use this to mount a humidity sensor for readability outside a container while the sensor remains inside. Designed specifically so I could easily view the humidity within the sealed storage container that contains my filament. You can snap the hygrometer into the outer casing with ease; it will hold tight due to tabs on the inside. Is it a perfect seal? Definitely not, but it's not bad. The casing was printed in PETG. Included are gaskets that should be printed twice; these were printed in TPE, so they're a little squishy. The Fusion 360 .f3d is included in case you need to make any modifications. I'll attach photos later once it's installed.