ECO-WORTHY 12V 30AH LiFePO4 Battery Bracket

grabcad

I designed this for 0.063" 5052 Aluminum being cut and bent by SendCutSend. Specs for k factor, etc have been set from SendCutSend's specs. Holes on the side are designed for M4 bolts to pass through. The 30AH battery recently had it's dimensions changed by eco-worthy, so make sure your battery matches these dimensions. 3.3"x7.2"x6.9"I designed this to fit in the cargo area of the Jeep JLU Cargo space under the trunk floor, although it will work on any flat surface I presume. There are no 'containing' tabs on the back because that will be up against a wall, and will allow for variances in length incase eco-flow changes dimensions again. I've left the width a bit wide so that I could add some foam padding, and I left the sides a bit short in height so that the mating surface doesn't come into direct contact to prevent rubbing or any rattling.The attached photos show the bracket as it came from SendCutSend. The spacing around it is perfect for some foam to be applied to the bracket. If oyu want it to fit tighter, you can remove an 1/8th of an inch from the width of the top plate and it would be pretty snug.