Eclipson model C anchor nut for square nut

prusaprinters

<p>The standard anchor nut for the model C isn't great. This one takes a square nut which is much easier to fixate.</p><p>The original anchor for the model C has a nut-hole that is too large for the required M3 nut, and will spin around if you don't glue it in. After fully assembling the body I came to this conclusion which was a pain to fix without throwing the whole body into the trash.</p><p>Be kind to yourself: get some square M3 nuts and print these nut anchors instead.</p><p>Press the nut into the hole all the way with a screwdriver. It should be very tight in the hole. If you have a hard time just scale the model 2% in the direction that doesn't fit for you.</p><p>Print this model with the large flat side facing down, the sidewith the cross cut-out. No supports required.</p><p>FYI This model is for this (great) model airplane: <a href="https://www.eclipson-airplanes.com/modelc">https://www.eclipson-airplanes.com/modelc</a></p>