Echo Dot Stand

thingiverse

This is an Echo Dot V2 stand I crafted using 123D Design, adding a decorative flair while boosting the overall sound volume. The design is entirely original, and remixes are enthusiastically encouraged. Print Settings: Printer: Flashforge Creator Pro Rafts: It doesn't matter. Supports: No Resolution: .2 mm Infill: 20% Rectilinear, grid, or Triangular fill pattern Notes: When printing the Echo Dot V2 with PLA, it fits perfectly; however, I haven't experimented with other materials. A precise fit might necessitate a minor amount of rescaling with different filaments. It takes approximately four to five hours to print at 80mm/s. The dimensions work well with PLA but may result in a slightly tight fit with ABS, possibly requiring scaling to around 1.1%. The circular slot on the bottom accommodates a strand of Ninjaflex filament, preventing it from sliding on smooth surfaces. Simply insert a piece of Ninjaflex into the slot after printing, if needed. This feature is optional but available for use. A hole through the bottom facilitates removal of the Dot from the Stand when the fit becomes extremely tight; simply push the Dot free with the eraser side of a pencil. I utilized Simplify3D to slice and print this model. It was designed using 123D Design and sliced with Simplify3D.