Echo Dot 3 Wall Socket Mount UNICORN EDITION

thingiverse

I have added an experimental remix that is a single piece print with more cable room. I liked the idea of the original make, however, the first one I printed had issues - the retainer clips broke and so did the tab to hold the Echo dot 3, also it didn't install well if glued first. So I modified it as follows: 1) I significantly thickened the retaining tab to hold the Echo Dot 3 for more strength 2) I added a cut out that allows the cord to be installed after gluing the two parts together While I was at it, I figured I would make it more girly since my daughter is the one that uses it. So I enclosed the plug holder and added a raised unicorn and sprinkled stars around the rest. (I used paint pens to kick up the looks a bit) I will eventually also post this without the unicorn. Let me know if you need a blank one before I do. *** I think I can layer these into a single piece print... will try that soon and if so I will upload that file Use supports! Fill ratio should be 60% so the tabs don't break