EBR-75 FL-10 turret (France)

thingiverse

This is the larger turret for the EBR-75 model offered earlier, scaled to 1:76. The dimensions are believed to be accurate. Designed to fit on the previous model, it has yet to undergo testing. Created using 3D Builder after converting an early skin model from a .max format file sourced from various places - not a trivial task as Yobi3D struggled with the file. Some antennas and other elements were removed but little else changed. Note that the long gun is difficult to support; trying to add special supports to stabilize the high and narrow barrel resulted in failure. A locating pin was added, allowing it to print successfully after splitting the barrel off. Hopefully both this turret and the earlier FL-11 model could be used on an AMX-13 hull if a suitable starting point can be found... Just tested fit on EBR-75 model; results seem fine. A 'make' will be published later.