eB Fan Shroud 5015 Fan - Creality (CR) Touch mount

thingiverse

This is for the "eBFan Shroud 5015 fan remix." I'm using Ender 3 Pro and bought a CR Touch (Creality Touch) - no existing mounts have fit the CR Touch's cable clearance so I designed this one. The Bracket allows you to move the CR Touch to the height you need for the proper calibration. This is how you instal: 1. Unmount your heat sink for the hot end 2. Unscrew the top-left wheel and pull the bolt out. 3. Align the two holes for the heat sink with the CR Touch Mount 4. Install one of the brackets that came bundled with your CR Touch (Ender 3 V2 Bracket) to the CR Touch. Install the Bracket to the CR Mount by using any small size screw + bolt that you have. Don't tighten them too much as you will need to adjust the height. 5. Assemble everything else back - hot end, eB Shroud, Fans, etc. 6. move the nozzle's Z-axis all the way down until the tip of the nozzle touches the print bed. 7. Grab an Allen Key that has a width of 3mm and place it right below where the tip of the CR Touch is. 8. Lower the bracket by loosening the screw until the tip of CR Touch is touching the Allen Key. Tighten the screw and you're ready to calibrate your new CR Touch.