EasyGrip Lever - Effortless Door Opening Lever

thingiverse

Ever had your hands full or dirty and struggled to open a door? The EasyGrip Lever is here to lend a hand. Simply install it on your doorknob, and you can effortlessly use your elbow to open the door. This is especially handy for those stubborn old doorknobs.There are two versions available - v1 (depicted in the photos) is thicker and longer, using a bit more material. While I've also printed v2 for a friend, I haven't captured a photo of it yet. Both versions are designed for 54mm knobs, though v2 has a 1mm larger diameter. I've found adding a layer or two of quality electric tape around the rim provides better friction on the knob.If your door knob isn't 54mm in diameter, simply adjust the x-y-z scaling in your slicer. You'll only need one M3 screw, and the hole should fit snugly without the need for a heat set.These models are easy to print without support. Filament I used was Kexcelled ABS K5P CHAMPAIGN GOLD.