Easy to Print Bob-omb!

myminifactory

Watch this video for more information about this model: https://youtu.be/hOwLgcKgQb8. Today I'm sharing a 3D Printable Bob-omb from Mario. This design is engineered to be as easy to print as possible, resulting in one piece with no supports required. It's completely scalable so you can go big or small depending on your printer's capabilities. I printed this model on my Robo 3D R1 printer using Hatchbox White PLA at 50mm/sec. It took approximately 9 hours to complete at a 0.3mm layer height, and it used around 220g of filament at the size I chose. Post-processing steps include sanding any rough spots to your liking, followed by priming with plastic primer and allowing it to dry completely between coats. Next, paint everything except the body using an airbrush. Mask off the painted areas, leaving only the main body unpainted. Then, paint the main body with black spray paint. Finally, once dry, apply a glossy finish for a shiny look. Print settings are as follows: Layer Height - 0.3mm, Infill - 20%, Supports - No, Raft - No. Easy to Print Bob-omb! by ChaosCoreTech is licensed under the Creative Commons - Attribution license.