Easy to Print Bob-omb!

cults3d

Watch this video for more information about this model: https://youtu.be/hOwLgcKgQb8. Today I'm sharing a 3D Printable Bob-omb from Mario that's incredibly easy to print. This design prints in one piece without needing any supports, making it perfect for beginners or experts alike. It's completely scalable, so you can print it as big or small as your printer allows. I printed this model on my Robo 3D R1 printer using Hatchbox White PLA at a speed of 50mm/sec. The printing time was approximately 9 hours with a layer height of 0.3mm, and I used about 220g of filament. Post-processing is a breeze: First, sand any rough spots to your liking. Next, prime it with plastic primer, allowing each coat to dry completely before applying the next one. Then, paint everything except the body (my wife used an airbrush). After that, mask off the painted areas, leaving only the main body unpainted. Following that, paint the main body using black spray paint. Once dry, give it a glossy finish with a spray coat to achieve a shiny look. Here are my print settings: Layer Height: 0.3mm Infill: 20% Supports: None Raft: No