Easy Face Shield

grabcad

EASY face shield designed for printers will smaller build plate. Leaves room for glasses or masks and clear plastic can be attached using a standard 3 hole punch.Instructable can be seen here:https://www.instructables.com/id/The-Easy-Face-Shield/Assembly video here:https://youtu.be/gym9bxymmWoStackable v3 video here:https://youtu.be/9DczuSu2s0cUpdates for Version 2:More forehead room for glasses and larger respiratorsrubber band hooks have been redesigned, one is now a hole for a loop and the other is a larger hook so the band cannot fall off and it is easier to wear"nubs" to hold plastic sheeting have been reduced in size by 0.015" with additional fillets to make it easier for installation of plastic sheets, especially for thicker sheet stockUpdates for Version 3:nubs are now centered on shield and supported with ribsholes on forehead rest have been removedchanges to allow stacking during printstacks are separated by 0.013"ENABLE RETRACTION BETWEEN LAYER CHANGE DURING SLICEUpdates for Version 4:four additional sizes added, XS, S, L, and XLshield size from v1-3 labeled as Msizes shown on right side frameforehead rest smoothed for paddingsee included size chart PDFOverall build size will fit on a 150mm x 150mm bed for versions 1-3 and size M for v4