Easy drain filter / trap

thingiverse

This is a straightforward drain filter designed for so-called easy drains. It was specifically created to be inverted and positioned under the metal easy drain to allow as much water to pass through as possible. If it were to sink in, the overall open area size of the filter would be significantly lower than its current design. If you're unfamiliar with easy drains, a quick search will yield the necessary information: https://www.google.com/search?q=easy+drain You can modify this design using the customizer tool; however, keep the following points in mind: - Avoid making the holes too small. The recommended hole size is greater than 6. - Don't make the distance between the hexacons too small. The recommended hexacon thickness is greater than 1.5. - Measure the drain size accurately. The code will automatically add a 1mm tolerance to ensure a snug fit. When printing this design using Cura, consider these settings under "before layer change": The height range of 10.5 to 12 corresponds to the rim's location. ``` ; Default 100% speed M220 S100 ; Slow down at the rim {if layer_z > 10.5 && layer_z < 12}M220 S50{endif} ; Slow down at the first two layers {if layer_num < 3}M220 S50{endif} ```