Easy Change Filament Holder #FilamentChallenge

thingiverse

Filament Challenge Lift Your Filament with Ease The challenge is clear: make lifting your filament out of the stand a breeze. Our filament spool, inspired by the Makerbot spool, seamlessly integrates with other spools too. Get Ready for Smooth Results Our instructions are straightforward and easy to follow: print this holder without any supports. "FilamentPin" and "FilamentMid" should be printed vertically at 0.20mm height for optimal results. Infill and shells vary based on personal preference, but we recommend a moderate 5-10% infill rate and two layers of shells. With these settings, the entire print should consume approximately 100 grams of filament. We've rigorously tested Version 2 to ensure its reliability in ABS. Good luck printing and enjoy!