Easy and speed Arch Light using PVC V2.0 (FR instructions)

thingiverse

Human: Almost the same description as the original arch except for the modification of the supports and the addition of a screw to make a vice with the edge of the desk ensuring better maintenance and stability of the entire set. You will be able to move freely without the arch slipping or falling. Which was the case in the past, with the first version. Addition of details for printing. For the led tape clips and the connector to join two pvc plates, retrieve them from the first version. Arch for desk lighting. Less restrictive and faster to implement than a full 3D print. Just print the supports for the desk. Arch made with a 30mm x 3mm x 214mm (260mm shortened) pvc plate. Total printing time in 0.2mm layer height, at a speed of 50mm/s: approximately 4h30 minutes against approximately 50-60 hours for the other, smaller one. PS: Possibility to make an arch with a shorter or longer reach. The "block cover" serves to close the hole allowing the passage of the led tape while leaving the smaller power cord free. For thickness, to place supports, it is designed for plates or desks with a standard 18mm protruding edge. The 39.1 led tapes are for use with isoplanes that would serve as tables. For the prints themselves, you will need: 1 Led Tape Port (supports: yes, do not print supports at the level of the screw) 1 Full Led Tape Port (supports: yes, do not print supports at the level of the screw) 1 Block Cover (supports: yes) 2 led tape screws (supports: no) Outside of 3D printing: pvc plate of 3cm width and 3mm thickness and led tape (minimum of 5050 to 60 led/meter with white light for good lighting). And double-sided scotch if not wishing to print clips or for esthetics without clip or other. As needed. ;) PS: Advice when setting up in case: place the double-sided scotch on the pvc plate before placing it in the supports on the desk, then once placed, glue inside the scotch, the led tape to avoid the opposite work of flexion at the arch by the led tape.