Easy Adjust Bar Clamp M12 threaded rod

thingiverse

This is a clamp built using an M12 threaded rod. One of the two clamps can be adjusted quickly and easily, simply tilt it slightly and slide it, then it returns to its horizontal position and the washer inserted inside locks onto the threaded rod. The other clamp is tightened with a handle that houses the M12 joint. In addition to the three pieces to be printed, you will need: - 1 x M12 threaded rod (any length) - 2 x M12 washers (outer diameter 24 mm) - 1 x M12 joint (length 30 mm) One of the washers must be inserted into the slot of the sliding clamp. Edit 19/08/2019 The v2 version of the clamp adds a knurl to the clamp surface, which provides better grip on the piece. It also corrects a design error by removing the joined part at the bottom of the flat part of the clamp to hold pieces at 90 degrees more securely. Edit 18/11/2019 I created a new version with feet and a larger handle.