Easy Access E3D V5 SINGLE fan duct holder

thingiverse

The original was created by trustfm. I remixed this because I had difficulties with the plastic ties, which have to be cut every time to service the E3D's. This version introduces a pivot and locking mechanism, making both fans really accessible. The original had tight parameters around the fan ducts, which made them difficult to remove. Both fan ducts are left untouched from the originals, so they should work with my version (assuming you printed "Fan-Duck-Left_-_repaired_-_oriented" and "Fan-Duck-Right_-_repaired_-_oriented"). I did repair the right side to fix the slicing errors. For right hand version print: E3D_V5_Right_Side_FAN_Body_PIVOT_PT1 E3D_V5_Right_Side_FAN_Body_PIVOT_PT2 Fan-Duck-Right_-_repaired_-_oriented For Left hand version print: E3D_V5_Left_Side_FAN_Body_PIVOT_PT1 E3D_V5_Left_Side_FAN_Body_PIVOT_PT2 Fan-Duck-Left_-_repaired_-_oriented Recommend printing settings: -Layer height: 0.2 -use 2mm Brim on both Fan Body PT's. Both parts are small and will detach from your heating bed. -use bridges Recommend hardware: 1x M3x30 hex bolt 1x M3x25 hex bolt 2x M3 locking nuts Enjoy! Print this and be done with your service issues! If you're new to E3D's, this will make your life very easy. You really don't need two fans. If your layers are separating, then your filament is cooling too quickly.