EastWhoop 80 - 1.6 inch printable HD frame

thingiverse

This is the 80mm 1.6 inch version of my Eastwhoop frame (95mm 2inch also available). Final build weight is 76g with a Nebula pro and naked Caddx Vista. 4 minutes flight time. Working both in "pusher" and "puller" mode. I started from Freezillon Racewhoop design (https://www.thingiverse.com/thing:4608171). 24mm between the plates, 80mm motor to motor. Lipo strap holder is on the bottom plate and requires a 10mm large strap Caddx vista is stared on top plate (20x20), and FC on bottom plate (25.5x25.5 or 16x16) I also printed this to hold caddx vista antenna: https://www.thingiverse.com/thing:4638027 and this standoff (increased to 5mm for vista separator and 3 or 4 mm for FC) https://www.thingiverse.com/thing:2807615 Other parts used: M2 Screws, titanium to save weight: 10mm x 4 (FC) 12mm x2 (half Vista) 15mm x7 (bottom plate + cam mount + half Vista) 12mm x3 (top plate) Of course ou can use bigger screws (30mm) to stare ducts and plates together but I prefer with 2 screws. UPDATE 10/04/2021: - Increase lens protection lenght of Nebula pro camera holder - Add photo of the final build UPDATE 22/03/2021: - Improve all parts. Old still compatible UPDATE 03/06/2021: - Improve nebula cam mount Used gear: AIO 25.5x25.5 board (BetaFPV, Iflight Succex, ...) Mamba Toka 1103 8500kv. Should be ok with 1202 too. Caddx Vista 3S 550mah Nano RX (crossfire or r-xsr, standed behind the camera)