east3D Gecko duetwifi mount and 5" panel-due housing

thingiverse

This is a Duet WiFi mount and PanelDue enclosure set for the East3D Gecko. (Added a PanelDue touch-pen and SD card slot pen holder for the top of the PanelDue) (Model images may not be correctly positioned on build plate) How to Install: 1- Build your screen and install the 4-pin cable. 2- Install and screw the PanelDue into the faceplate of the new housing. 3- Screw the PanelDue housing back plate to the base. 4- Screw the PanelDue housing back plate and front together. 5- Run the 4-pin wire through the big hole where the original screen was, then mount and screw in the base from the backside of the Gecko's faceplate through the screen mounting holes. 6- Install the Duet WiFi mount to the original ledge hole pattern using the original screws. 7- Mount the Duet WiFi to the mount. Wire up and done. What You Will Need: 4x M3x4mm (to mount the PanelDue in the case) 1x M3x6mm (to screw down the PanelDue board) 4x M3x6mm (to connect the back panel to the front of the screen case) 2x M3x6mm (to connect the screen case to the base) And the original M3 screws from the Lerdge screen are used to attach the base to the Gecko's faceplate screen mounting holes.