EasiYo Yoghurt maker replacement lid outer

prusaprinters

My EasiYo yoghurt maker lid fractured due to heat and UV damage, so instead of going to a shop to buy a replacement (now in multiple colours!), "I make a new one". This is a simple OpenSCAD hull() design which fits nicely on the original red inner part of the lid replacing the outer shell. There is a polystyrene disc insulating disc sandwiched in the middle, which was a bit snug so v2.0 has an extra 5mm of height. The outer curves are gentle to allow printing without supports. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Infill: Low for insulation Notes: Prints without supports upside down. I used black PETG filament, as that's was in the Ender 3v2 printer. White perhaps would be better! How I Designed This This is a simple OpenSCAD hull() design - three cylinders 'wrapped', then repeated slightly smaller to carve out the inner. Category: Kitchen & Dining