Easier Snoo To Print

thingiverse

I decided to print Snoo for a customer from the Reddit/3D Hubs give-away offer, but without supports. Printing with supports can be tedious and time-consuming, requiring extra finishing work afterwards. I preferred to take the easier route and simplify the printing process. Since Snoo was designed specifically for SLA printing, I figured out a way to adapt it so it would print flawlessly from front to back, eliminating any need for assembly later on. Instead of sending my original print to the customer, which wasn't actually printed that way, I chose to add some extra details, like superglue "eyes", right after printing. This little figurine was created using Tinkercad. You can edit it online here: https://www.tinkercad.com/things/2zvLM98ovXO Print Settings: Printer: FlashForge Creator Pro Rafts: None used. Supports: None added either. Resolution: 0.10mm Infill: 100% Notes: Due to its small size (just 2.5cm tall) and the fragile nature of the antenna, I decided on 100% infill. This ensured that my prints wouldn't snap easily in half, avoiding the need for additional supports and tedious finishing work later down the line. Post-Printing: Standard cleaning and then giving Snoo some "eyes" with superglue To ensure a smooth finish and get rid of any stringing, I used an exacto knife to clean up the prints and remove excess material.