earrings holder

myminifactory

This design enters the Vectary Design Competition sponsored by MakeXA. It's a flower to hold earrings and a cone for rings, perfect for bedside tables. The full-size model measures 162.5 x 163 x 74.4 mm, requiring about 15 hours to print. For a reduced version at 60%, holes are 2mm in diameter, with a bounding box of 97.5 x 97.8 x 44.6 mm. This brings the print time down to approximately 4.5 hours. Currently being printed on Cocoon using translucent purple ABS: photo 1 after the first few layers, then at about 40% complete and lastly near the end of printing while still on the print bed. Additional photos will be shared showing earrings attached. The limited height only allows for very short earrings. Reviews from chief usability testers indicate a couple of improvement cycles: see 'earrings holder 2' (https://www.myminifactory.com/object/43954) and 'earrings holder 3' (https://www.myminifactory.com/object/44723). This model was created with VECTARY, the free online 3D modeling tool. Credits: model by rigtig181