Earring Holder

pinshape

This is a straightforward earring holder design I conceptualized for a buddy of mine. There are two designs - the primary holder and lower tray are simple single piece prints. The upper, middle, and lower body are more modular in design, allowing you to add or remove as needed. These parts are connected with 1/8" dowel pins, approximately 1/4" long, and held together with glue. I discovered that a .3 MM nozzle works better than a .4 for printing this design, but a .4 will still produce satisfactory results if you keep an eye on your retraction count. To mount the unit to the wall, you'll need some small finishing nails. The mounting holes are 7.75" apart from each other. Be sure to check out the video showcasing this design here: