Eaglemoss 1/8 Delorean Flux band Bracket

thingiverse

This is a specialized bracket for the Eaglemoss 1/8 Delorean. You can utilize the same screws mentioned in the built manual. There are two versions: one that puts the EL light wire through a hole, and another where it can be pushed into an opening. This design is tailored for 1.5mm EL wire. To complete this project, you will need approximately 12 of these brackets. You will then have some extras left over. When printing with FDM technology, a 0.25mm nozzle is recommended to ensure a precise fit. For resin printers, use good settings; otherwise, the bracket might be too tight. After printing, simply slide these onto the rails for an authentic look of the flux band. If you print them in a flexible material, you may be able to attach the flux band later, but test this first. Remember to enjoy the building process!