Eachine Pro58 cover Fatshark Attitude V3 V4

thingiverse

Eachine unveils a new high-performance FPV receiver for Fatshark goggles called Pro58. This cutting-edge module is powered by an advanced STM32F1 processor that can be paired with a variety of firmwares. Key details about the Eachine Pro58 can be found on RC Groups at https://www.rcgroups.com/forums/showthread.php?2904311-Eachine-PRO58-RX-Diversity-40CH-5-8G-OLED-SCAN-VRX-FPV-Receiver. Unfortunately, the module bay on the Fatshark Attitude V3/V4 is slightly too small to accommodate most Dominator receivers. However, with a simple bridge built from pin headers, it's possible to fit at least the Eachine Pro58 onto the Attitude V3/V4 goggles without needing to grind or mill. BOM: * 1pc. 9-pin curved male header pin with 2.54mm spacing * 1pc. 9-pin female header with 5mm high version (normal is 8/8.5mm) and 2.54mm spacing * 1pc. This 3D Printed STL Modification steps: * Install the curved header into the socket of the goggles and mount the female header on the Pro58. * Place the module on the googles, ensuring that the module pins are approximately between the curved pins (no picture available) with both headers having contact. * Remove the module and bend the pins slightly in the direction of the corresponding curved header pin. Verify again. * If satisfied, apply 2 drops of super glue carefully to the curved header plastic and install the module. Wait until the glue is cured and then remove the unit. Next, glue the complete plastic together. * Solder the pins together. * If using Achilles FW https://achillesfpv.eu/, add the OSD mod on the back side. I added a small Picoblade cable for upcoming updates as well. * Reinstall the bridge and module. * Cover has a slight fit. Apply some doubled-sided tape between googles and cover if needed. Enjoy this high-performance FPV receiver on your Attitude!