Eachine EV800DM FPV goggles monitor case

thingiverse

I thought the PCB from the Eachine EV800DM goggles would make a sweet little FPV display. Note that this design leaves out the internal battery and charging circuit entirely. I disconnected the internal battery connector, then installed a voltage regulator that takes 2-6S input and outputs 4.2V to the board. The DC charging connector was also removed, and no cut-out for it was made in the case since I wouldn't be using it. The hole for the wires into the voltage regulator is designed for 18AWG silicone wires with a layer or two of heatshrink applied. I printed the two halves of the case in PLA - only time will tell if it gets too warm and needs to be reprinted in PETG. The cover is PETG because it has just the right amount of flexibility. I scaled the cover up by 0.1% in my slicer to get a nice fit. You'll need four M3x18 countersunk head bolts and four M3 nuts to put everything together.