E6V6 - Ender 6 v6 / Dragon mount

cults3d

Updated to include shorter fan mounts, if you have trouble with the fan mounts not clearing your extruder, these should fix the issue. I have tried to include everything you might need to fit a v6 / volcano / dragon hotend to your ender 6. It has adjustable fan mounts for dual 50515's & blower style 4010's (the original parts fan). It can be used with the v6 30mm? hotend fan and shroud or you can print the included version and use a 40mm fan(standard ender 6 hotend fan). It has mounts for bltouch, ezabl 12 & 18mm, all can be mounted to the left of the hotend or if using 2 5015's in front of the hotend, with the abl sensor in front you will loose a small amount of printable area, unless you regularly print using the entire bed this is unlikely to cause any issues.It hasnt for me or any of the people that have tested the setup. Everything is made to directly fit the ender 6, the hotend clamps on tightly with m3 screws and captive m3 nuts, the fans bolt into place with 1x10mm m3 per side plus the hardware to mount the fan 1x m4x20mm for a 5015 or 2x m2x10 for the 40mm blower fan. Its easier to fit than my explanation. I love the mmm v6 mount and my design uses the same techniques, with changes to support dual fans etc. Everything was designed from scratch in fusion360. There have been over 16 revisions with minor changes and everything has been tested. The download include stl's ready to be printed for, the v6 base mount and clamp, 40mm extra short hot end shroud, 5015 mounts for both sides, 40mm blower fan mounts for both sides, cable relief for bowden setups, cable relief for direct drive setups, (moves cabling to the left) Left hand mounts for bltouch and ezabl center mounts for a bltouch or ezabl the fan mounts are adjustable over 10mm, so you can fit a volcano heat block without needing to print anything new. I have been using this setup for a few months while revising and improving it until it was ready to share. The printed parts in the images where all printed really fast as i was testing changes, they will look nicer with a lower speed and layer heights, some bits where printed with .8 nozzle and were not really suitable for it Im working on a rigid mount for the dragon, it will be included in this kit when its finished. If you have any problems fitting or using this please give me a shout