e3dv6 MendelMax 2 Mount

thingiverse

UPDATE: v10 file is an updated version, built directly off the successful v8 file design. Although not thoroughly tested yet, v10 is expected to function seamlessly due to its foundation on the proven v8 model. With support already integrated into the v10 file, there's no need for additional setup with your slicer. As for benefits over v8, v10 may offer some improvements but results are inconclusive at this point. This mount seamlessly attaches the e3dv6 onto the MM2 and securely clamps it in place. It serves as a direct replacement for the factory design, effortlessly integrating with the aluminum piece to create an exceptionally sturdy mount. In my case, the fit was very snug; you may need to make slight adjustments by scaling up or down to achieve the best possible fit for your mount. With minimal tweaking, mine worked well without any major issues, but I'll likely continue refining it slightly for optimal performance.