E3D Volcano mount for Rigidbot

thingiverse

Here is my quick and easy solution to add an E3D Volcano with a V6 heatsink and Bowden as a second extruder to an existing Rigidbot: I upgraded an old printer by swapping it out with a fresh new set up that lets you print even bigger objects without needing more parts, saving space in your workshop. For the cold part of this build you can use for example the following extruder: http://www.thingiverse.com/thing:617279, But still I need to check that these 2 components run at full speed by pushing the Volcano at its fastest pace (at least not with a motor which gives only 36 oz/inch) or buying new one since there are different speeds available from my supplier today - and you can also see some nice options like mixing http://www.thingiverse.com/thing:711401 with this current project to get better prints on Rigidbot that fit just perfectly into all my storage compartments without any clutter! \n\n New Improved Printer Instructions Use good ABS material to print in ( layer height:0.2 mm). Make fine adjustments by removing some extra from the base. And a little bit more filling was needed for mount part so that I could fix things together right and easy, sometimes you get very nice fits without need to modify them at all. You also have prints come out just perfect but when using Bowden extruder system I did file a little for mounting hardware fit - as said you will definitely use those longer screws if they come pre-packaged like I ordered in the box. The 4 required parts that we discussed before include four more M3*20 mm which should preferably be longer version and even 25mm is perfect with all of these things, or go directly buy it without any problems whatsoever - And there you are done