E3D V6 split fan shroud

cults3d

I combined a 30mm fan duct with a filament cooler duct. I am taking about one third of the air from the heat sink and diverting it to the filament on the bed. I wanted to minimize the weight on my effector and I wanted to cool the heat sink and the printed material with one fan. I got tired of this thing breaking when I snap it on and off so I added a rib on the sides for some extra strength. There is a tiny 5mm brim - trim away post print. And the screw holes for the fan should be drilled out a little. No supports No rafts No fat chicks I would print this in ABS due to the temperature it will be exposed to (hence the 5mm brim) And I made a stand alone diverter. You can sandwich this thing between a 30mm fan and an E3D V6 heat sink shroud.You will need some long skinny screws though. BUYER BEWARE! I just found out that taking 1/3 of the air from the heat sink is a bad idea. It doesn't cool quite enough, and I end up with clogs. I am working on a 3 fan model again. Related Things: effector 2640121 carriages 2653647 fan shroud 2846998 UBL adapter 2847002