E3D v6 and Titan extruder Cyclone layer fan Makergear M2

E3D v6 and Titan extruder Cyclone layer fan Makergear M2

thingiverse

Human: 30mm Extruder Fan Mount Plus Magnetic Quick Detach Cyclonic Layer Fan. Uses two 8x2mm neodymium magnets (one in each part), which then allows for quick removal of the layer fan shroud for easy maintenance/nozzle clearing. If you don't care about that, the two parts can simply be glued together. Fan Shroud is 270 degrees to allow extruder to move fully to the right for a pre-print purge. Works best with the heater block orientated "backwards", long part towards the back of the printer (see mounted photos). Radial Fan Simply Slides on Top of Downtube. Depending on your print calibration/settings, you may need to lightly massage the locating tabs with a needle file as they are designed to be a tight fit to avoid wobble. You may also like to pre-drill the fan mounting holes to make screwing the fan mount screws in easier depending on what mount screws you are using. Been Getting Great Results With It, Very Even and All Round Airflow Distribution, 100% Is Very Powerful and I Find 40% Works Extremely Well with Formfutura TitanX Which is What It Is Printed In. I Printed the Radial Fan Shroud Upright, and the 30mm Fan Mount with the Fan Face Down. Your Mileage May Vary. Edit - Slightly Tweaked the 30mm Fan Mount Dimensions. If You Were an Early Downloader Then Would Recommend You Re-Download That Part. Nothing Major, Just Slightly Shallower Tab to Sit More Square Against Titan Extruder Body and a Smidge More Clearance in the Female Tab Alignment Slots.

Download Model from thingiverse

With this file you will be able to print E3D v6 and Titan extruder Cyclone layer fan Makergear M2 with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on E3D v6 and Titan extruder Cyclone layer fan Makergear M2.