E3D to CR6-SE adapter V1

thingiverse

I brought an E3D hotend off Of Amazon by mistake and rather than sending it back I thought i'd look if there were any adapters around for it. I did find some but they 'just' didn't quite do it for me so I decided to remix a couple of them that I liked until I got it just right! The hotend will fit in perfectly and allow bolting to the rear with recessed nut spaces (might be a tight fit, they're M3). It's an AIO package so you only need to print the version you want, I've done 2, 1 with small sidewalls and 1 without, I use the 1 with for more front to back support else I found it bowed inwards so the choice is yours! Better to build with supports for the fan section but can be done without but will probably end up a little messy like mine did!