E3D Titan Extruder w/ 12-18mm Sensor and BLTouch Mounts for Prusa i3

thingiverse

This is a revised version of the E3D Titan Extruder upgrade for Prusa i3 by Gyrobot, featuring a small mount that holds a 12mm inductive sensor firmly in place using two M3x20mm screws and nuts. Install the Titan extruder and hotend to the carriage before attaching the sensor holder and sensor. The Prusa i3 guide by Gyrobot and E3D's titan assembly guide can be found on the E3D Wiki. Printed in black PLA with Cura, using optimal print settings for a professional finish. Edit 22/06/2016: A new sensor mount was added, featuring an 18mm design that prints well and holds the sensor perfectly. The same installation method applies as the original 12mm sensor mount. Edit 04/08/2016: Printing in ABS or PETG for the sensor mount and carriage is recommended to ensure durability against heat from the bed at 100c, which can cause deformation and affect bed level. A reprint of the carriage and sensor holder in ABS was performed as a result. Edit 21/09/2016: An untested BLTouch mount was added. Edit 19/10/2016: The BLTouch mount has been tested and functions well with the upgraded printer system. Print Settings Printer Brand: RepRap Printer: Prusa i3 Rafts: No Supports: No Resolution: 0.3mm Infill: 25% Notes: Recommend printing in ABS or PETG for optimal durability and resistance to heat deformation from the print bed.