E3D Titan Extruder Upgrade for Prusa i2

thingiverse

This lets you install a new E3D Titan on any horizontal bar printer. Most printers of this type don't come with tensioners, so one is included. If the tensioner isn't needed, fold the belt over double to the right and clamp it down.\nThere's no magic in assembling this part; just zip tie the bearings first and then assemble the rest.\nBOM:\n3x M3 nuts 15mm or longer\n2x M3 screws 23mm or longer\n5x Zip Tie\n6x Nuts\n1x Plate\n1x Belt Tensioner Loop\n1x Screw Holder\n2x Holds\nThis part was designed in Fusion 360 and is fully parametric. You can change bearing dimensions, zip tie dimension, rod spacing, M3 hole size, nut size, and the offsets from the rear rod and belt.\nThe file can be downloaded or viewed here: http://a360.co/20qVGHY\nPrint Settings\nPrinter Brand:\nRepRap\nPrinter:\nPrusa i2\nRafts:\nNo\nSupports:\nNo\nResolution:\n.2\nInfill:\n40\nNotes:\nThis part prints without a raft. There's no complicated geometry or overhangs, so it shouldn't be a problem.\nThe part was designed in Fusion 360 and is fully parametric. You can change bearing dimensions, zip tie dimension, rod spacing, M3 hole size, M3 nut size, and the offsets from the rear rod and belt. The file can be downloaded (or just looked at) here: http://a360.co/20qVGHY