E3D Titan Extruder prusa i3 X carriage

thingiverse

I've combined the fan duct mount with the titan extruder mount into one single part, eliminating the need for an additional spacer since my screws were too short to fit both. I also included the duct and inductive sensor mount from my setup, which was necessary due to the rear-mounted fan interfering with the printer frame's side panel. Print Settings: Printer: Prusa i3 clone Rafts: No Supports: Yes Resolution: 0.2 Infill: Yes - 20% Notes: I printed this part in PLA without any issues over several weeks, but ABS would be a better choice if available. Supports were essential for the underside to ensure neatness around the bearings and to facilitate printing the fan shroud bracket without them. Infill was set at approximately 20% for added strength and a smooth top layer.