E3D Sensor mount for the Hypercube

thingiverse

An effortless and secure way to attach the LJ12A3-4-Z Inductive Proximity Sensor to the Hypercube 3d printer. Note: You may find it too loose or too tight, requiring a slight adjustment in size to fit your probe perfectly. It's best to test before mounting it to the main e3d x-axis mount. Clip it in and out a few times beforehand. Parts: The same screw size fitting as the original mount is used (M3 screw). Directions: My approach involves moving the nozzle down at the center of the bed, about a paper width away, and using a 1mm steel ruler to set the height of the probe before clipping it on. Clip in the sensor at the desired height and then tighten the nuts firmly into place. I use 'm48 p10 x100 y100 v2 e l2' to test the repeatability of the probe. More information can be found at https://github.com/pflannery/Hypercube/blob/master/auto-leveling.md. Tools: A Hex Screw driver tool kit and a Hex Nut key Socket Screw driver tool kit are recommended. I use sets made by E-Sky, but cheaper options can be found on banggood or ali-express.