E3D or V6 Clone - Direct Feed to Bowden Adapter, mount, and fang for STOCK CR10, Ender 2, 3, 4.

prusaprinters

<p>Thank you to @FinneganFalco for the original design.</p> <p>I accidentally ordered the Direct Feed V6 hotend clone instead of a Bowden version. As usual, I thought "challenge accepted!"</p> <p>Using the same ideas as my extruder plate design, this adapter allows you to mount @FinneganFalco's fang and 40mm fan duct to an otherwise direct feed V6 hotend clone or the original E3D hotend.</p> <p>Using the incorporated pressure fitting and nut, slide your ptfe tube up against the hotend and tighten the nut. You can now use the cheaper Direct Feed hotend without a Bowden fitting.</p> <p>Enjoy and post your makes!</p> <h3><em>If you found my Things useful, treat me to a cup of coffee by using the PayPal button below :)</em> Buy me a cup of coffeeBuy me a cup of coffee $3.00 USDBuy me a massive cups of coffee $5.00 USDGive me a caffeine coma $10.00 USD Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p><strong>Printer:</strong></p> <p>Ender 3</p> <p><strong>Rafts:</strong></p> <p>No</p> <p><strong>Supports:</strong></p> <p>Yes</p> <p><strong>Resolution:</strong></p> <p>.15</p> <p><strong>Infill:</strong></p> <p>30%</p> <h3><strong>Filament:</strong> Inland PLA Peak Green How I Designed This</h3> <p><strong>Fresh off the press. Print the mount with a 85 degree support to build plate only. I use 20% support density using "lines" and they pop right off.</strong></p> <p><strong>Printing like a champ! Just make sure the PTFE tube is about .5mm below the coupler and making contact with the top of the hot end.</strong></p> Category: 3D Printer Accessories